New M&P Shield 9Mm, Slide Not Locking Back After Firing Last Round
The notch goes past the lever. It's several tasks that, when added together, can become frustrating. It is one of the more complicated skills, but when you figure out those details locking the slide to the rear isn't as tough as many think. Join Date: Dec 2010. The bore line/slide line should be in line with the forearm.
- M&p shield 9mm slide won't lock back utility
- M and p shield 9mm compact disassembly
- M&p shield 9mm slide won't lock back folding
- M&p shield 9mm slide won't lock back to top
M&Amp;P Shield 9Mm Slide Won't Lock Back Utility
Hornady's 200gr XTP round gave me a few 2 ¾" groups, but everything I fired was within a quarter of an inch, one way or another, of the 3" mark. If you are still having issues, seek out professional instruction and/or comment below for more feedback and discussion. THE ONLY CLEANER & LUBE YOU NEED. M&p shield 9mm slide won't lock back utility. Aftermarket sights are available. You are clearing the gun at the end of a training session or for other administrative reasons and need to lock it open to inspect the chamber to make sure it is empty. I don't even bother locking it back anymore, I just rotate the lever while holding the slide. There are numerous issues with this approach. CORRECT METHOD OF LOCKING THE SLIDE TO THE REAR.
M And P Shield 9Mm Compact Disassembly
Sure enough, it became jammed so tightly that I was unable to move it in either direction. It will lock back after it fires the last round just fine. Pull Back and Push Up: When I work with students, I find that a lot of folks have a problem locking the slide to the rear because they are unaware of exactly what needs to happen for the slide to actually lock back. Location: NW Indiana.
M&Amp;P Shield 9Mm Slide Won't Lock Back Folding
At the four o'clock position, IWB, no one could tell I was armed. After that, they tell you to release or ride the slide forward with the support hand until the slide locks to the rear. All of the controls are on the left side on the 45 SHIELD, none on the right. The lever that rotates is the slide release(takedown) lever. I use Original Gun Oil on all my firearms. It is also the way I typically store a handgun. M&P Pro slide won't lock - S&W (M&P, etc. Your dealer didn't make you jump through those hoops? Now that you have upward pressure on the slide-stop lever, you can take your support hand up and over the slide, behind the ejection port and grip onto the slide. O You have a gun whose trigger needs to be pulled to do a basic field strip to clean it. Not having a range anywhere near my current residence is also a problem.
M&P Shield 9Mm Slide Won't Lock Back To Top
The next magazine out was mine. This method does require more strength and muscle endurance because we have to hold the slide to the rear or at least back far enough that we can find and then activate the slide stop so it locks the slide to the rear. I found out you have to snatch the slide back, it does not like to be babied! In other words, you shouldn't have your fingers splayed. The middle-finger knuckle should have contact with the bottom of the trigger guard and all other strong-hand fingers should be wrapped around the grip with no space between the fingers. Racking the Slide: Why Can’t I Lock the Slide Back. Liked 36 Times in 16 Posts. Now you are all done and your Smith & Wesson Shield EZ is fixed and ready to go to the range.
Three-inch groups or slightly better from a striker-fired EDC compact with a 3. What am I doing wrong? 45ACP makes the M&P 45 SHIELD a solid choice for personal self-defense. You should also start pushing up on the lever. Anybody else experience this? Pull it back further. In fact, with a bit of practice, it will become one skill that is easy to perform whenever needed. I shot Blazer and Winchester 230gr FMJs, Hornady's 200grain XTPs, Remington Golden Saber 185gr HPs and CAP Arms 230 grain XTPs. Been there, done that. M&p shield 9mm slide won't lock back folding. Any ideas before I have to send it back to S&W and be without it for a few weeks? Locks back fine all other times though.