Vacuum Line Routing Ford 460 Vacuum Diagram
It is for Bill/85LebaronT2's truck, which is an '86. So, to answer your question, Bill said the blue thing, the choke pulloff, goes to manifold vacuum. It has a bleeder system (cover on back) so is harder to test than a plain one. Thunder: This is based on the younger brother to the AFB, the Air Valve Secondary (AVS). Vacuum line routing ford 460 vacuum diagram 102 2ee. However, those carbs are across three different carb lines: Performer: This is essentially the original Carter AFB, which was a very good carb. Maybe we can find the right one. But the Thunder/AVS has an extremely easy-to-use adjustment on the secondary opening point. Now I am looking at the vacuum lines. But, that page doesn't include the vacuum choke pull-off that your choke needs.
- Vacuum line routing ford 460 vacuum diagram pdf
- Vacuum line routing ford 460 vacuum diagram images
- Vacuum line routing ford 460 vacuum diagram
- Vacuum line routing ford 460 vacuum diagram 102 2ee
Vacuum Line Routing Ford 460 Vacuum Diagram Pdf
Vapor Recovery: As said in the email, there's a system to recover the vapor from the evaporating petrol. I've attached a photo with the lines marked. But, they also have a 650 and a 750 CFM carb. Daily Driver 2009 Flex Limited with factory tow package.
Vacuum Line Routing Ford 460 Vacuum Diagram Images
I have rebuilt the carb and stopped the gas leaks. So it doesn't really apply. The tube running from the gas tank should go to one or two charcoal canisters sitting low on the right frame rail, probably below the battery. "Getting old is inevitable, growing up is optional".
Vacuum Line Routing Ford 460 Vacuum Diagram
AVS2: This is a new carb and I'm not au fait with it. But, from reading about it I think it is the Thunder/AVS with annular discharge venturiis. So if you keep that carb you'll need vacuum to that. HOWEVER, the diagram above is not for your truck. This should be helpful on economy, but then I'm not sure "economy" and "460" should populate the same sentence. But, it is possible that the original hoses had a colour tracer on them, so you might look for that. It is the choke pull-off and opens the choke (strangler) blade after a few seconds of running. I want to be sure I am plumbed properly. Vacuum line routing ford 460 vacuum diagram printable. But from what I've read the 4350 is a 600 CFM carb, so if you are just wanting to match that an Edelbrock 600 CFM carb would work. I'm running the 750 CFM version on my 460.
Vacuum Line Routing Ford 460 Vacuum Diagram 102 2Ee
Any input would be great. The choke control is a bimetallic spring in the choke cover which gets it's heat from the exhaust crossover passage in the intake manifold. I was just using it for an example. Here we specialize in 1980 - 86 trucks. Last edited by a moderator: The major difference between the AFB and the AVS is the adjustable secondary opening point. So, let's talk carbs. The tube in the back of the choke housing should get quite hot fairly soon after starting the engine, if it does not look for a broken tube (rusted through) or the inlet tube (goes next to it) being blocked or used as a vacuum source by mistake. 2L Turbo II, modified A413.